JEE Advanced 2024 Paper 1 Online | Units & Measurements Question 5 | Physics

A dimensionless quantity is constructed in terms of electronic charge $e$, permittivity of free space $\varepsilon_0$, Planck's constant $h$, and speed of light $c$. If the dimensionless quantity is written as $e^\alpha \varepsilon_0{ }^\beta h^\gamma c^\delta$ and $n$ is a non-zero integer, then $(\alpha, \beta, \gamma, \delta)$ is given by :

$(2 n,-n,-n,-n)$

$(n,-n,-2 n,-n)$

$(n,-n,-n,-2 n)$

$(2 n,-n,-2 n,-2 n)$

JEE Advanced 2023 Paper 2 Online

MCQ (Single Correct Answer)

-1

Young's modulus of elasticity $Y$ is expressed in terms of three derived quantities, namely, the gravitational constant $G$, Planck's constant $h$ and the speed of light $c$, as $Y=c^\alpha h^\beta G^\gamma$. Which of the following is the correct option?

$\alpha=7, \beta=-1, \gamma=-2$

$\alpha=-7, \beta=-1, \gamma=-2$

$\alpha=7, \beta=-1, \gamma=2$

$\alpha=-7, \beta=1, \gamma=-2$

JEE Advanced 2022 Paper 2 Online

MCQ (Single Correct Answer)

-1

Area of the cross-section of a wire is measured using a screw gauge. The pitch of the main scale is $0.5 \mathrm{~mm}$. The circular scale has 100 divisions and for one full rotation of the circular scale, the main scale shifts by two divisions. The measured readings are listed below.

Measurement condition	Main scale reading	Circular scale reading
Two arms of gauge touching each other without wire	0 division	4 divisions
Attempt-1: With wire	4 divisions	20 divisions
Attempt-2: With wire	4 divisions	16 divisions

What are the diameter and cross-sectional area of the wire measured using the screw gauge?

$2.22 \pm 0.02 \mathrm{~mm}, \pi(1.23 \pm 0.02) \mathrm{mm}^{2}$

$2.22 \pm 0.01 \mathrm{~mm}, \pi(1.23 \pm 0.01) \mathrm{mm}^{2}$

$2.14 \pm 0.02 \mathrm{~mm}$, $\pi(1.14 \pm 0.02) \mathrm{mm}^{2}$

$2.14 \pm 0.01 \mathrm{~mm}, \pi(1.14 \pm 0.01) \mathrm{mm}^{2}$

JEE Advanced 2021 Paper 1 Online

MCQ (Single Correct Answer)

-1

The smallest division on the main scale of a Vernier calipers is 0.1 cm. Ten divisions of the Vernier scale correspond to nine divisions of the main scale. The figure below on the left shows the reading of this calipers with no gap between its two jaws. The figure on the right shows the reading with a solid sphere held between the jaws. The correct diameter of the sphere is

JEE Advanced 2021 Paper 1 Online Physics - Units & Measurements Question 11 English

JEE Advanced 2021 Paper 1 Online Physics - Units & Measurements Question 11 English

3.07 cm

3.11 cm

3.15 cm

3.17 cm

Previous Next

JEE Advanced Subjects