JEE Advanced 2014 Paper 1 Offline | Properties of Matter Question 30 | Physics

Heater of an electric kettle is made of a wire of length L and diameter d. It takes 4 minutes to raise the temperature of 0.5 kg water by 40 K. This heater is replaced by a new heater having two wires of the same material, each of length L and diameter 2d. The way these wires are connected is given in the options. How much time in minutes will it take to raise the temperature of the same amount of water by 40 K?

4, if wires are in parallel

2, if wires are in series

1, if wires are in series

0.5, if wires are in parallel

JEE Advanced 2013 Paper 1 Offline

MCQ (More than One Correct Answer)

-1

A solid sphere of radius R and density $$\rho $$ is attached to one end of a mass-less spring of force constant k. The other end of the spring is connected to another solid sphere of radius R and density 3$$\rho $$. The complete arrangement is placed in a liquid of density 2$$\rho $$ and is allowed to reach equilibrium. The correct statement(s) is (are)

The net elongation of the spring is $${{4\pi {R^3}\rho g} \over {3k}}$$

The net elongation of the spring is $${{8\pi {R^3}\rho g} \over {3k}}$$

The light sphere is partially submerged

The light sphere is completely submerged

IIT-JEE 2012 Paper 1 Offline

MCQ (More than One Correct Answer)

-2

A person blows into the open end of a long pipe. As a result, a high-pressure pulse of air travels down the pipe. When this pulse reaches the other end of the pipe,

a high-pressure pulse starts travelling up the pipe, if the other end of the pipe is open.

a low-pressure pulse starts travelling up the pipe, it the other end of the pipe is open.

a low-pressure pulse starts travelling up the pipe, if the other end of the pipe is closed.

a high-pressure pulse starts travelling up the pipe, if the other end of the pipe is closed.

IIT-JEE 2011 Paper 1 Offline

MCQ (More than One Correct Answer)

-2

A composite block is made of slabs A, B, C, D and E of different thermal conductivities (given in terms of a constant K) and sizes (given in terms of length, L) as shown in the figure. All slabs are of same width. Heat Q flows only from left to right through the blocks. Then, in steady-state

IIT-JEE 2011 Paper 1 Offline Physics - Properties of Matter Question 16 English

heat flow through A and E slabs are same.

heat flow through slab E is maximum.

temperature difference across slab E is smallest.

heat flow through C = heat flow through B + heat flow through D.

Previous Next

Questions Asked from MCQ (Multiple Correct Answer)

JEE Advanced Subjects