Engineering Mechanics
Engineering Mechanics Static and Dynamics
Marks 1Marks 2
1
GATE ME 2005
MCQ (Single Correct Answer)
+2
-0.6
Two books of mass 1 kg each are kept on a table, one over the other. The coefficient of friction on every pair of contacting surfaces is 0.3. the lower book is pulled with a horizontal force F. the minimum value of F for which slip occurs nbetween the two books is
A
zero
B
1.06 N
C
5.74 N
D
8.83 N
2
GATE ME 2005
MCQ (Single Correct Answer)
+2
-0.6
A shell is fired from a cannon. At the instant the shell is just about to leave the barrel, its velocity relative to the barrel is 3m/s, while the barrel is swinging upwards with a constant angular velocity of 2 rad/sec. The magnitude of the absolute velocity of the shell is GATE ME 2005 Engineering Mechanics - Engineering Mechanics Static and Dynamics Question 57 English
A
3 m/s
B
4 m/s
C
5 m/s
D
7 m/s
3
GATE ME 2005
MCQ (Single Correct Answer)
+2
-0.6
A 1 kg mass of clay, moving with a velocity of 10 m/s, strikes a stationary wheel and sticks to it. The solid wheel has a mass of 20 kg and a radius of 1 m. assuming that the wheel and the ground are both rigid and that the wheel is set into pure rolling motion, the angular velocity of the wheel immediately after the impact is approximately GATE ME 2005 Engineering Mechanics - Engineering Mechanics Static and Dynamics Question 52 English
A
Zero
B
1/3 rad/s
C
$$\sqrt {{{10} \over 3}} \,\,rad/s$$
D
10/3 rad/s
4
GATE ME 2004
MCQ (Single Correct Answer)
+2
-0.6
The figure below shown a pair of pin jointed gripper tongs holding an object weighing $$2000N$$. The coefficient of friction (µ) at the gripping surface is $$0.1$$ $$XX$$ is the line of action of the input force and $$Y - Y$$ is the line of application of gripping force. If the pin joint is assumed to be frictionless, the magnitude of force $$F$$ required to hold the weight is GATE ME 2004 Engineering Mechanics - Engineering Mechanics Static and Dynamics Question 60 English
A
$$1000$$ $$N$$
B
$$2000$$ $$N$$
C
$$2500$$ $$N$$
D
$$5000$$ $$N$$
GATE ME Subjects
Engineering Mechanics
Machine Design
Strength of Materials
Heat Transfer
Production Engineering
Industrial Engineering
Turbo Machinery
Theory of Machines
Engineering Mathematics
Fluid Mechanics
Thermodynamics
General Aptitude