Engineering Mechanics
Engineering Mechanics Static and Dynamics
Marks 1Marks 2
1
GATE ME 2007
MCQ (Single Correct Answer)
+2
-0.6
A block of mass $$M$$ is related from point $$P$$ on a rough inclined plane with inclination angle $$\theta $$, shown in the figure below. The coefficient of friction is $$\mu $$. If $$\mu < \tan \theta $$, then the time taken by the block to reach anorher point $$Q$$ on the inclined plane, where $$PQ=S,$$ is GATE ME 2007 Engineering Mechanics - Engineering Mechanics Static and Dynamics Question 21 English
A
$$\sqrt {{{2s} \over {g\cos \theta \left( {\tan \theta - \mu } \right)}}} $$
B
$$\sqrt {{{2s} \over {g\cos \theta \left( {\tan \theta + \mu } \right)}}} $$
C
$$\sqrt {{{2s} \over {gsin\theta \left( {\tan \theta - \mu } \right)}}} $$
D
$$\sqrt {{{2s} \over {gsin\theta \left( {\tan \theta + \mu } \right)}}} $$
2
GATE ME 2006
MCQ (Single Correct Answer)
+2
-0.6
If point A is in equilibrium under the action of the applied forces, the values of tensions and T AB and TAC are respectively. GATE ME 2006 Engineering Mechanics - Engineering Mechanics Static and Dynamics Question 51 English
A
520 N and 300 N
B
300 N and 520 N
C
450 N and 150 N
D
150 N and 450 N
3
GATE ME 2005
MCQ (Single Correct Answer)
+2
-0.6
An elevator (lift) consists of the elevator cage and a counter weight, of mass m each. The cage and the counterweight are connected by a chain that passes over a pulley. The pulley is coupled to a motor. It is desired that the elevator should have a maximum stopping time of t seconds from a peak speed $$V.$$ If the inertias of the pulley and the chain are neglected, the minimum power that the motor must have is GATE ME 2005 Engineering Mechanics - Engineering Mechanics Static and Dynamics Question 56 English
A
$${1 \over 2}m{V^2}$$
B
$${{m{V^2}} \over {2t}}$$
C
$${{m{V^2}} \over t}$$
D
$${{2m{V^2}} \over t}$$
4
GATE ME 2005
MCQ (Single Correct Answer)
+2
-0.6
Two books of mass 1 kg each are kept on a table, one over the other. The coefficient of friction on every pair of contacting surfaces is 0.3. the lower book is pulled with a horizontal force F. the minimum value of F for which slip occurs nbetween the two books is
A
zero
B
1.06 N
C
5.74 N
D
8.83 N
GATE ME Subjects
Engineering Mechanics
Machine Design
Strength of Materials
Heat Transfer
Production Engineering
Industrial Engineering
Turbo Machinery
Theory of Machines
Engineering Mathematics
Fluid Mechanics
Thermodynamics
General Aptitude