The flowing stress (in $$MPa$$) of a material is given by $$\sigma = 500{\varepsilon ^{0.1}},$$
When $$\varepsilon $$ is true strain. The Young's modulus of elasticity of the material is $$200$$ $$GPa.$$ A block of thickness $$100$$ $$mm$$ made of this material is compressed to $$95$$ $$mm$$ thickness and then the load is removed. The final dimension of the block (in $$mm$$) is ____________

In a slab rolling operation, the maximum thickness reduction $$\left( {\Delta {h_{\max }}} \right)$$ is given by $$\Delta {h_{\max }} = {\mu ^2}R,$$ where $$R$$ is the radius of the roll and $$\mu $$ is the coefficient of friction between the roll and the sheet. If $$\mu = 0.1,$$ the maximum angle subtended by the deformation zone at the center of the roll (bit angle in degrees) is ____________

In a rolling operation using rolls of diameter $$500mm,$$ if a thick plate cannot be reduced to less than $$20mm$$ in one pass, the coefficient of friction between the roll and the plate is ____________.

A metal rod of initial length $${L_0}$$ is subjected to a drawing process. The length of the rod at any instant is given by the expression, $$L\left( t \right) = {L_0}\left( {1 + {t^2}} \right),$$ where $$t$$ is the time in minutes. The true strain rate (in $${\min ^{ - 1}}$$) at the end of one minute is _____________