Transportation Engineering
Highway Devolopment and Planning
Marks 1Marks 2
Highway Geometric Design
Marks 1Marks 2
Traffic Engineering
Marks 1Marks 2
Highway Materials
Marks 1Marks 2
Pavement Design
Marks 1Marks 2
Railway, Runway and Taxiway Design
Marks 1
1
GATE CE 2025 Set 1
Numerical
+1
-0

Road A and Road B are joined by a circular horizontal curve of radius 200 m as shown in the figure. Road $A$ and Road $B$ are tangential to the curve at the points $C$ and $D$, respectively. Had the curve not been there, straight roads $A$ and $B$ would have met at the point $E$. The distance from $C$ to $E$ is 92 m . The value of angle $\theta$ (in degrees) is

__________ (rounded off to 1 decimal place).

Note: The value of angle .. is to be calculated only from the consideration of Euclidean geometry and the data given in the problem.

GATE CE 2025 Set 1 Transportation Engineering - Highway Geometric Design Question 1 English

Your input ____
2
GATE CE 2024 Set 2
MCQ (Single Correct Answer)
+1
-0.33

The longitudinal sections of a runway have gradients as shown in the table.

End to end for sections of runway (m)Gradient (%)
0 to 200+1.0
200 to 600−1.0
600 to 1200+0.8
1200 to 1600+0.2
1600 to 2000−0.5

Consider the reduced level (RL) at the starting point of the runway as 100 m.

The effective gradient of the runway is

A

0.02%

B

0.35%

C

0.28%

D

0.18%

3
GATE CE 2024 Set 2
MCQ (Single Correct Answer)
+1
-0.33

In general, the outer edge is raised above the inner edge in horizontal curves for

A

Highways, Railways, and Taxiways

B

Highways and Railways only

C

Railways and Taxiways only

D

Highways only

4
GATE CE 2024 Set 1
MCQ (Single Correct Answer)
+1
-0.33

As per the International Civil Aviation Organization (ICAO), the basic runway length is increased by $x$ (%) for every $y$ (m) rise in elevation from the Mean Sea Level (MSL). The values of $x$ and $y$, respectively, are

A

7% and 300 m

B

5% and 200 m

C

4% and 500 m

D

10% and 1000 m

GATE CE Subjects
Engineering Mechanics
Strength of Materials Or Solid Mechanics
Structural Analysis
Construction Material and Management
Reinforced Cement Concrete
Steel Structures
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
Hydrology
Irrigation
Geomatics Engineering Or Surveying
Environmental Engineering
Transportation Engineering
Engineering Mathematics
General Aptitude