Geotechnical Engineering
Origin of Soils
Marks 1
Definitions and Properties of Soils
Marks 1Marks 2
Classification of Soils and Clay Mineralogy
Marks 1
Effective Stress and Permeability
Marks 1Marks 2
Seepage Analysis
Marks 1Marks 2
Compaction of Soil
Marks 1Marks 2
Compressibility and Consolidation
Marks 1Marks 2
Shear Strength of Soil
Marks 1Marks 2
Stress Distribution of Soil
Marks 1Marks 2
Retaining Wall and Earth Pressure
Marks 1Marks 2
Stability of Slopes
Marks 1Marks 2
Shallow Foundation
Marks 1Marks 2
Pile Foundation
Marks 1Marks 2
Soil Stabilization
Marks 1
1
GATE CE 2024 Set 1
Numerical
+2
-0

An infinite slope is made up of cohesionless soil with seepage parallel to and up to the sloping surface. The angle of slope is 30° with respect to the horizontal ground surface. The unit weights of the saturated soil and water are 20 kN/m3 and 10 kN/m3, respectively.

The minimum angle of shearing resistance of the soil (in degrees) for the critically stable condition of the slope is ________________ (rounded off to the nearest integer).

Your input ____
2
GATE CE 2024 Set 1
Numerical
+2
-0

A soil sample was consolidated at a cell pressure of 20 kPa and a back pressure of 10 kPa for 24 hours during a consolidated undrained (CU) triaxial test. The cell pressure was increased to 30 kPa on the next day and it resulted in the development of pore water pressure of 1 kPa. The soil sample failed when the axial stress was gradually increased to 50 kPa. The pore water pressure at failure was recorded as 21 kPa. The value of Skempton's pore pressure parameter B for the soil sample is ________________ (rounded off to 2 decimal places).

Your input ____
3
GATE CE 2016 Set 1
Numerical
+2
-0
The porosity (n) and the degree of saturation (S) of a soil sample are 0.7 and 40%, respectively. In a 100 $$m^3$$ volume of the soil, the volume (expressed in $$m^3$$) of air is _____.
Your input ____
4
GATE CE 2015 Set 2
Numerical
+2
-0
A 588 $$cm^3$$ volume of moist sand weighs 1010 gm. Its dry weight is 918 gm and specific gravity of solids, G is 2.67. Assuming density of water as 1 gm/$$cm^3$$, the void ratio is __________.
Your input ____
GATE CE Subjects
Engineering Mechanics
Strength of Materials Or Solid Mechanics
Structural Analysis
Construction Material and Management
Reinforced Cement Concrete
Steel Structures
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
Hydrology
Irrigation
Geomatics Engineering Or Surveying
Environmental Engineering
Transportation Engineering
Engineering Mathematics
General Aptitude