Electrical Machines
Induction Machines
Marks 1Marks 2
Synchronous Machines
Marks 1Marks 2Marks 5
1
GATE EE 2016 Set 1
MCQ (Single Correct Answer)
+1
-0.3
In a constant V/f induction motor drive, the slip at the maximum torque
A
is directly proportional to the synchronous speed
B
remains constant with respect to the synchronous speed
C
has an inverse relation with the synchronous speed
D
has no relation with the synchronous speed
2
GATE EE 2015 Set 2
Numerical
+1
-0
The figure shows the per-phase equivalent circuit of a two-pole three-phase induction motor operating at 50 Hz. The 'air-gap' voltage, Vg across the magnetizing inductance, is 210Vrms, and the slip, s, is 0.05. The torque (in Nm) produced by the motor is ________. GATE EE 2015 Set 2 Electrical Machines - Induction Machines Question 59 English
Your input ____
3
GATE EE 2014 Set 2
MCQ (Single Correct Answer)
+1
-0.3
In a constant V/f control of induction motor, the ratio V/f is maintained constant from 0 to base frequency, where V is the voltage applied to the motor at fundamental frequency f. Which of the following statements relating to low frequency operation of the motor is TRUE?
A
At low frequency, the stator flux increases from its rated value.
B
At low frequency, the stator flux decreases from its rated value.
C
At low frequency, the motor saturates.
D
At low frequency, the stator flux remains unchanged at its rated value.
4
GATE EE 2014 Set 2
MCQ (Single Correct Answer)
+1
-0.3
A three-phase, 4-pole, self excited induction generator is feeding power to a load at a frequency $$f_1$$. If the load is partially removed, the frequency becomes $$f_2$$. If the speed of the generator is maintained at 1500 rpm in both the cases, then
A
$$f_1,f_2$$ > 50Hz and $$f_1$$ > $$f_2$$
B
$$f_1$$ < 50Hz and $$f_2$$ > 50Hz
C
$$f_1,f_2$$ < 50Hz and $$f_2$$ > $$f_1$$
D
$$f_1$$ > 50Hz and $$f_2$$ < 50Hz
GATE EE Subjects
Electromagnetic Fields
Signals and Systems
Engineering Mathematics
General Aptitude
Power Electronics
Power System Analysis
Analog Electronics
Control Systems
Digital Electronics
Electrical Machines
Electric Circuits
Electrical and Electronics Measurement