ExamSIDE
Questions (Powered by ExamGOAL)
Strength of Materials Or Solid Mechanics
Centroid and Moment of Inertia
Marks 1Marks 2
Torsion
Marks 1Marks 2
Pure Bending
Marks 1Marks 2
Shear Stress In Beams
Marks 1Marks 2
Strain Energy Method
Marks 1Marks 2
Columns and Struts
Marks 1Marks 2
Complex Stress
Marks 1Marks 2
Deflection of Beams
Marks 1Marks 2
Thin Cylinder
Marks 1Marks 2
Simple Stresses
Marks 1Marks 2
Shear Force and Bending Moment
Marks 1Marks 2
Propped Cantilever Beam
Marks 1Marks 2
Previous Next
1
GATE CE 2014 Set 1
MCQ (Single Correct Answer)
+2
-0.6
If the following equation establishes equilibrium in slightly bent position, the mid-span deflection of a member shown in the figure is
$${{{d^2}y} \over {d{x^2}}} + {P \over {EI}}y = 0$$ GATE CE 2014 Set 1 Strength of Materials Or Solid Mechanics - Columns and Struts Question 4 English

If $$'a'$$ is amplitude constant for $$y,$$ then

A
$$y = {1 \over P}\left( {1 - a\,\cos {{2\pi x} \over L}} \right)$$
B
$$y = {1 \over P}\left( {1 - a\,sin{{2\pi x} \over L}} \right)$$
C
$$y = a\,\sin {{n\pi x} \over L}$$
D
$$y = a\,\cos {{n\pi x} \over L}$$
2
GATE CE 2012
MCQ (Single Correct Answer)
+2
-0.6
The sketch shows a column with a pin at the base and rollers at the top. It is subjected to an axial force $$P$$ and a moment $$M$$ at mid-height. The reaction$$(s)$$ at $$R$$ is/are GATE CE 2012 Strength of Materials Or Solid Mechanics - Columns and Struts Question 5 English
A
a vertical force equal to $$P$$
B
a vertical force equal to $$P/2$$
C
a vertical force equal to $$P$$ and a horizontal force equal to $$M/h$$
D
a vertical force equal to $$P/2$$ and a horizontal force equal to $$M/h$$
3
GATE CE 2008
MCQ (Single Correct Answer)
+2
-0.6
Cross-section of a column consisting of two steel strips, each of thickness $$t$$ and width $$b$$ is shown in the figure below. The critical loads of the column with perfect bond and without bond between the strips are $$P$$ and $${P_0}$$ respectively. The ratio $$P/{P_0}$$ is GATE CE 2008 Strength of Materials Or Solid Mechanics - Columns and Struts Question 6 English
A
$$2$$
B
$$4$$
C
$$6$$
D
$$8$$
4
GATE CE 2008
MCQ (Single Correct Answer)
+2
-0.6
A rigid bar $$GH$$ of length $$L$$ is supported by a hinge and a spring of stiffness $$K$$ as shown in the figure below. The buckling load, $${P_{cr}}'$$ for the bar will be GATE CE 2008 Strength of Materials Or Solid Mechanics - Columns and Struts Question 7 English
A
$$0.5$$ $$KL$$
B
$$0.8$$ $$KL$$
C
$$1.0$$ $$KL$$
D
$$1.2$$ $$KL$$
Previous Next
Questions Asked from Marks 2
GATE CE 2024 Set 2 (1) GATE CE 2017 Set 1 (1) GATE CE 2014 Set 1 (1) GATE CE 2012 (1) GATE CE 2008 (2) GATE CE 2007 (1) GATE CE 2006 (1) GATE CE 2005 (1) GATE CE 1990 (1)
GATE CE Subjects
Engineering Mechanics
Strength of Materials Or Solid Mechanics
Structural Analysis
Construction Material and Management
Reinforced Cement Concrete
Steel Structures
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
Hydrology
Irrigation
Geomatics Engineering Or Surveying
Environmental Engineering
Transportation Engineering
Engineering Mathematics
General Aptitude