Power System Analysis
Per Unit System
Marks 1Marks 2
Power Generation Cost
Marks 1Marks 2Marks 5
Power System Stability
Marks 1Marks 2Marks 5
Symmetrical Components and Symmetrical and Unsymmetrical Faults
Marks 1Marks 2Marks 5
Circuit Breaker
Marks 1Marks 2Marks 5
Switch Gear and Protection
Marks 1Marks 2Marks 5
Load Flow Studies
Marks 1Marks 2Marks 5
High Voltage Dc Transmission
Marks 1
Generating Power Station
Marks 1Marks 2
Parameters and Performance of Transmission Lines
Marks 1Marks 2Marks 5
1
GATE EE 2014 Set 3
Numerical
+2
-0
For a $$400$$ $$km$$ long transmission line, the series impedance is $$(0.0 + j0.5)$$ $$\Omega /km$$ and the shunt admittance is $$(0.0 + j5.0)$$ $$\mu \,mho/km.$$ The magnitude of the series impedance (in $$\Omega $$) of the equivalent $$\pi $$ circuit of the transmission line is __________.
Your input ____
2
GATE EE 2014 Set 2
MCQ (Single Correct Answer)
+2
-0.6
The horizontally placed conductors of a single phase line operating at $$50$$ $$Hz$$ are having outside diameter of $$1.6$$ cm, and the spacing between centers of the conductors is $$6$$ m. The permittivity of free space is $$8.854 \times {10^{ - 12}}\,\,F/m.$$ The capacitance to ground per kilometer of each line is
A
$$4.2\,\, \times \,\,{10^{ - 9}}F$$
B
$$8.4\,\, \times \,\,{10^{ - 9}}F$$
C
$$4.2\,\, \times \,\,{10^{ - 12}}F$$
D
$$8.4\,\, \times \,\,{10^{ - 12}}F$$
3
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+2
-0.6
A two bus power system shown in figure supplies load of $$1.0+j0.5$$ $$p.u$$ GATE EE 2014 Set 1 Power System Analysis - Parameters and Performance of Transmission Lines Question 27 English

The value of $${V_1}$$ in $$p.u$$ and $${\delta _2}$$ respectively are

A
$$0.95$$ and $${6.00^0}$$
B
$$1.05$$ and $${-5.44^0}$$
C
$$1.1$$ and $${-6.00^0}$$
D
$$1.1$$ and $${27.12^0}$$
4
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+2
-0.6
A distribution feeder of $$1$$ $$km$$ length having resistance, but negligible reactance, is fed from both the ends by $$400$$ $$V,$$ $$50$$ $$Hz$$ balanced sources. Both voltage sources $${S_1}$$ and $${S_2}$$ are in phase. The feeder supplies concentrated loads of unity power factor as shown in the figure. GATE EE 2014 Set 1 Power System Analysis - Parameters and Performance of Transmission Lines Question 28 English

The contributions of $${S_1}$$ and $${S_2}$$ in $$100$$ $$A$$ current supplied at location $$P$$ respectively, are

A
$$75$$ $$A$$ and $$25A$$
B
$$50A$$ and $$50A$$
C
$$25A$$ to $$75A$$
D
$$0A$$ and $$100A$$
GATE EE Subjects
Electromagnetic Fields
Signals and Systems
Engineering Mathematics
General Aptitude
Power Electronics
Power System Analysis
Analog Electronics
Control Systems
Digital Electronics
Electrical Machines
Electric Circuits
Electrical and Electronics Measurement