1
GATE PI 2010
MCQ (Single Correct Answer)
+2
-0.6
A small bore is designated as $$25H7.$$ The lower (minimum) and upper (maximum) limits of the bore are $$25.000mm$$ and $$25.021$$ respectively. When the bore is designated as $$25H8,$$ then the upper limit is $$25.033mm.$$ When the bore is designated as $$25H6,$$ then the upper limit of the bore in $$mm$$ is
2
GATE PI 2009
MCQ (Single Correct Answer)
+2
-0.6
An autocollimator is used to
3
GATE PI 2009
MCQ (Single Correct Answer)
+2
-0.6
Match the following
4
GATE PI 2008
MCQ (Single Correct Answer)
+2
-0.6
An experimental setup is planned to determine the taper of work piece as shown in the figure. If the two precision rollers have radii $$8mm$$ and $$5mm$$ and the total thickness of slip gauges inserted between the rollers is $$15.54mm,$$ the taper angle $$'\theta '$$ is
Questions Asked from Marks 2
GATE PI 2015 (2) GATE PI 2014 (1) GATE PI 2013 (1) GATE PI 2012 (1) GATE PI 2011 (2) GATE PI 2010 (1) GATE PI 2009 (2) GATE PI 2008 (2) GATE PI 2007 (2) GATE PI 2006 (2) GATE PI 2005 (1) GATE PI 2004 (1) GATE PI 1995 (2) GATE PI 1994 (1) GATE PI 1993 (2) GATE PI 1992 (2) GATE PI 1991 (1) GATE PI 1990 (1) GATE PI 1989 (1)
GATE PI Subjects
Fluid Mechanics
Metrology
Theory of Machines
Engineering Mathematics
Heat Transfer
Machine Tools and Machining
Industrial Engineering
Engineering Mechanics
Strength of Materials
Thermodynamics
Machine Design
Casting
Joining of Materials
Metal Forming