GATE CE 2006 | Pure Bending Question 5 | Strength of Materials Or Solid Mechanics

A beam with cross-section given below is subjected to a positive bending moment (causing compression at the top) of $$16$$ $$kN$$-$$m$$ acting around the horizontal axis. The tensile force acting on the hatched area of the cross-section is GATE CE 2006 Strength of Materials Or Solid Mechanics - Pure Bending Question 1 English

GATE CE 2006 Strength of Materials Or Solid Mechanics - Pure Bending Question 1 English

zero

$$5.9$$ $$kN$$

$$8.9$$ $$kN$$

$$17.8$$ $$kN$$

GATE CE 2003

MCQ (Single Correct Answer)

-0.6

A simply supported beam of uniform rectangular cross-section of width $$b$$ and depth $$h$$ is subjected to linear temperature gradient, $${0^ \circ }$$ at the top $${T^ \circ }$$ at the bottom, as shown in the figure. The coefficient of linear expansion of the beam material is $$\alpha .$$ This resulting vertical deflection at the mid-span of the beam is GATE CE 2003 Strength of Materials Or Solid Mechanics - Pure Bending Question 2 English

GATE CE 2003 Strength of Materials Or Solid Mechanics - Pure Bending Question 2 English

$${{\alpha {\mkern 1mu} {\mkern 1mu} T{h^2}} \over {8L}}{\mkern 1mu} $$ upward

$${{\alpha \,\,T{L^2}} \over {8h}}\,\,$$ upward

$${{\alpha {\mkern 1mu} {\mkern 1mu} T{h^2}} \over {8L}}{\mkern 1mu} $$ downward

$${{\alpha \,\,T{L^2}} \over {8h}}\,\,$$ downward

GATE CE 1992

MCQ (Single Correct Answer)

-0.6

The maximum bending stress induced in a steel wire of modulus of elasticity $$200$$ $$kN/m{m^2}$$ and diameter $$1$$ $$mm$$ when wound on a drum of diameter $$1$$ $$m$$ is approximately equal to

$$50\,N/m{m^2}$$

$$100\,N/m{m^2}$$

$$200\,N/m{m^2}$$

$$400\,N/m{m^2}$$

Questions Asked from Marks 2

GATE CE 2016 Set 2 (1) GATE CE 2014 Set 2 (1) GATE CE 2006 (1) GATE CE 2003 (1) GATE CE 1992 (1)

GATE CE Subjects

Engineering Mechanics

Strength of Materials Or Solid Mechanics

Structural Analysis

Construction Material and Management

Reinforced Cement Concrete

Steel Structures

Geotechnical Engineering

Fluid Mechanics and Hydraulic Machines

Hydrology

Irrigation

Geomatics Engineering Or Surveying

Environmental Engineering

Transportation Engineering

Engineering Mathematics

General Aptitude