The 3-phase modulating waveforms $\left(v_a(t), v_b(t), v_c(t)\right)$, used in sinusoidal PWM in a voltage source inverter (VSI) are

$$ \begin{aligned} & v_a(t)=0.8 \sin (\omega t) \vee \\ & v_b(t)=0.8 \sin \left(\omega t-\frac{2 \pi}{3}\right) \vee \\ & v_c(t)=0.8 \sin \left(\omega t+\frac{2 \pi}{3}\right) \vee \end{aligned} $$

where $\omega=2 \pi \times 40 \mathrm{rad} / \mathrm{s}$ is the fundamental frequency. The modulating waveforms are compared with a 10 kHz triangular carrier whose magnitude varies between +1 and -1 . The VSI has a DC link voltage of 600 V and feeds a star connected motor. The per phase fundamental RMS motor voltage in volts is closest to

A single-phase full bridge voltage source inverter (VSI) feeds a purely inductive load. The inverter output voltage is a square wave in 180° conduction mode. The fundamental frequency of the output voltage is 50 Hz. If the DC input voltage of the inverter is 100 V and the value of the load inductance is 20 mH, the peak-to-peak load current in amperes is ________ (rounded off to the nearest integer).

Consider an ideal full-bridge single-phase DC-AC inverter with a DC bus voltage magnitude of 1000 V. The inverter output voltage v(t) shown below, is obtained when diagonal switches of the inverter are switched with 50% duty cycle. The inverter feeds a load with a sinusoidal current given by, $$i(t) = 10\sin \left( {\omega t - {\pi \over 3}} \right)A$$, where $$\omega = {{2\pi } \over T}$$. The active power, in watts, delivered to the load is __________. (round off to nearest integer).

A 3-phase grid-connected voltage source converter with DC link voltage of 1000 V is switched using sinusoidal Pulse Width Modulation (PWM) technique. If the rid phase current is 10 A and the 3-phase complex power supplied by the converter is given by ($$-$$4000 $$-$$ j3000) VA, then the modulation index used in sinusoidal PWM is _________. (round off to two decimal places).