Communications
Analog Communication Systems
Marks 1Marks 2
Digital Communication Systems
Marks 1Marks 2Marks 8Marks 10
Random Signals and Noise
Marks 1Marks 2Marks 4
Fundamentals of Information Theory
Marks 1Marks 2
Noise In Digital Communication
Marks 1Marks 2
1
GATE ECE 2023
MCQ (Single Correct Answer)
+2
-0.67

Let a frequency modulated (FM) signal $$x(t) = A\cos ({\omega _c}t + {k_f}\int_{ - \infty }^t {m(\lambda )d\lambda )} $$, where $$m(t)$$ is a message signal of bandwidth W. It is passed through a non-linear system with output $$y(t) = 2x(t) + 5{(x(t))^2}$$. Let $${B^T}$$ denote the FM bandwidth. The minimum value of $${\omega _c}$$ required to recover $$x(t)$$ from $$y(t)$$ is

A
$${B_T} + W$$
B
$${3 \over 2}{B_T}$$
C
$$2{B_T} + W$$
D
$${5 \over 2}{B_T}$$
2
GATE ECE 2023
MCQ (Single Correct Answer)
+2
-0.67

Let x$$_1$$(t) and x$$_2$$(t) be two band-limited signals having bandwidth $$B=4\pi\times10^3$$ rad/s each. In the figure below, the Nyquist sampling frequency, in rad/s, required to sample y(t), is

GATE ECE 2023 Communications - Analog Communication Systems Question 5 English

A
$$20\pi\times10^3$$
B
$$40\pi\times10^3$$
C
$$8\pi\times10^3$$
D
$$32\pi\times10^3$$
3
GATE ECE 2022
MCQ (Single Correct Answer)
+2
-0.67

Consider an FM broadcast that employs the pre-emphasis filter with frequency response

$${H_{pe}}(\omega ) = 1 + {{j\omega } \over {{\omega _0}}}$$,

where $$\omega$$0 = 104 rad/sec.

For the network shown in the figure to act as a corresponding de-emphasis filter, the appropriate pairs of (R, C) values is/are ____________.

GATE ECE 2022 Communications - Analog Communication Systems Question 6 English

A
R = 1 k$$\Omega$$, C = 0.1 $$\mu$$F
B
R = 2 k$$\Omega$$, C = 1 $$\mu$$F
C
R = 1 k$$\Omega$$, C = 2 $$\mu$$F
D
R = 2 k$$\Omega$$, C = 0.5 $$\mu$$F
4
GATE ECE 2017 Set 2
Numerical
+2
-0
The un-modulated carrier power in an AM transmitter is 5kW. This carrier is modulated by a sinusoidal modulating signal. The maximum percentage of modulation is 50%. If it is reduced to 40%, then the maximum un-modulated carrier power (in kW) that can be used without overloading the transmitter is ___________
Your input ____
GATE ECE Subjects
Signals and Systems
Network Theory
Control Systems
Digital Circuits
General Aptitude
Electronic Devices and VLSI
Analog Circuits
Engineering Mathematics
Microprocessors
Communications
Electromagnetics