Strength of Materials Or Solid Mechanics
1
GATE CE 2024 Set 1
MCQ (Single Correct Answer)
+2
-0.833
A homogeneous shaft PQR with fixed supports at both ends is subjected to a torsional moment T at point Q, as shown in the figure. The polar moments of inertia of the portions PQ and QR of the shaft with circular cross-sections are $J_1$ and $J_2$, respectively. The torsional moment reactions at the supports P and R are $T_P$ and $T_R$, respectively.
If $T_P/T_R = 4$ and $J_1/J_2 = 2$, the ratio of the lengths $L_1/L_2$ is:
2
GATE CE 2017 Set 2
Numerical
+2
-0
A hollow circular shaft has an outer diameter of $$100$$ $$mm$$ and inner diameter of $$50mm.$$ If the allowable shear stress is $$125$$ $$MPa$$, the maximum torque (in $$kN$$-$$m$$) that the shaft can resist is ___________
Your input ____
3
GATE CE 2011
MCQ (Single Correct Answer)
+2
-0.6
For the cantilever bracket, $$PQRS,$$ loaded as shown in the adjoining figure $$(PQ=RS=L,$$ and $$QR=2L),$$ which of the following statements is FALSE ?
4
GATE CE 2010
MCQ (Single Correct Answer)
+2
-0.6
A solid circular shaft of diameter d and length $$L$$ is fixed at one end and free at the other end. A torque t is applied at the free end. The shear modulus of the material is $$G.$$ The angle of twist at three free ends is
GATE CE Subjects
Engineering Mechanics
Strength of Materials Or Solid Mechanics
Structural Analysis
Construction Material and Management
Reinforced Cement Concrete
Steel Structures
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
Hydrology
Irrigation
Geomatics Engineering Or Surveying
Environmental Engineering
Transportation Engineering
Engineering Mathematics
General Aptitude