ExamSIDE
Questions (Powered by ExamGOAL)
Reinforced Cement Concrete
Singly Reinforced Sections
Marks 1Marks 2
Workmenship and Fundamentals
Marks 1Marks 2
Doubly Reinforced Sections
Marks 1Marks 2
Flanged Beams
Marks 1Marks 2Marks 5
Limit State of Collapse Shear
Marks 1Marks 2Marks 5
Limit State of Collapse Torsion
Marks 1Marks 2
Limit State of Collapse Compression
Marks 1Marks 2
Footings
Marks 2
Bond
Marks 1Marks 2Marks 5
Limit State of Serviceability
Marks 1Marks 2
Prestressed Concrete
Marks 1Marks 2Marks 5
Slabs
Marks 1Marks 2Marks 5
Next
1
GATE CE 2025 Set 2
MCQ (More than One Correct Answer)
+1
-0

In the context of construction materials, which of the following statements is/are CORRECT?

A
If the characteristic strength is defined as that value below which not more than $50 \%$ results are expected to fall, the target mean strength in mix design will be taken same as the characteristic strength irrespective of the degree of quality control expected at the site.
B
Ten percent fines value is a non-dimensional quantity.
C
The stress-strain curve of concrete for 1-day duration of loading is associated with a smaller secant modulus of elasticity compared to the stress-strain curve of the same concrete for 10-minutes duration of loading.
D
The increase of carbon in steel usually leads to an increase in its $0.2 \%$ proof stress.
2
GATE CE 2024 Set 1
MCQ (Single Correct Answer)
+1
-0.33

The following figure shows the arrangement of formwork for casting a cantilever RC beam.

GATE CE 2024 Set 1 Reinforced Cement Concrete - Workmenship and Fundamentals Question 3 English

The correct sequence of removing the Shores/Props is:

A

S1 → S2 → S3 → S4 → S5

B

S5 → S4 → S3 → S2 → S1

C

S3 → S2 → S4 → S1 → S5

D

S3 → S4 → S2 → S5 → S1

3
GATE CE 2017 Set 2
MCQ (Single Correct Answer)
+1
-0.3
Let the characteristic strength be defined as that value, below which not more than 50% of the results are expected to fall. Assuming a standard deviation of 4 MPa, the target mean strength (in MPa) to be considered in the mix design of a M25 concrete would be
A
18.42
B
21.00
C
25.00
D
31.58
4
GATE CE 2015 Set 1
MCQ (Single Correct Answer)
+1
-0.3
Consider the following statements for air-entrained concrete:

(i) Air-entrainment reduces the water demand for a given level of workability

(ii) Use of air-entrained concrete is required in environments where cyclic freezing and thawing is expected.

Which of the following is TRUE?
A
Both (i) and (ii) are True
B
Both (i) and (ii) are False
C
(i) is True and (ii) is False
D
(i) is False and (ii) is True
Next
Questions Asked from Marks 1
GATE CE 2025 Set 2 (1) GATE CE 2024 Set 1 (1) GATE CE 2017 Set 2 (1) GATE CE 2015 Set 1 (2) GATE CE 2014 Set 2 (3) GATE CE 2013 (1) GATE CE 2011 (1) GATE CE 2009 (1) GATE CE 2008 (1) GATE CE 2007 (1) GATE CE 2005 (2) GATE CE 2002 (1) GATE CE 1997 (2) GATE CE 1995 (1) GATE CE 1994 (1) GATE CE 1993 (1) GATE CE 1991 (1) GATE CE 1990 (2)
GATE CE Subjects
Engineering Mechanics
Strength of Materials Or Solid Mechanics
Structural Analysis
Construction Material and Management
Reinforced Cement Concrete
Steel Structures
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
Hydrology
Irrigation
Geomatics Engineering Or Surveying
Environmental Engineering
Transportation Engineering
Engineering Mathematics
General Aptitude